Bag clip with sealing ridge
19 min1 part
Bag clip for coffee bags
3D printing1 partBeginner-friendlyNo supports
A long bag clip for coffee bags, so the aroma stays in after opening. Fold the top of the bag over once and clip it shut: the clip takes bags up to 130 mm wide, and its 15 mm wide jaws press the bag into the groove along its whole length. It is 146.5 mm long and prints flat in one piece. Also good for tea, flour or sugar in large bags.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 146.5 × 32.87 × 15 mm
- Print time
- ≈ 31 min
- Filament
- ≈ 13 g PETG
- Parts
- 1
Print settings
- Material
- PETG
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print flat as shown, without supports – the clip comes off the printer open. Close it once after printing: press the arms together until the upper arm clicks in under the nose of the hook. To open, push the tab of the hook outwards. PETG springs best and copes with the freezer; PLA works too.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size as printed: 146.5 × 32.9 mm, 15 mm high
- Clamping length 130 mm, 15 mm wide
- With sealing ridge and groove
- Hole in the spring: 6 mm, to hang it up
This model comes from the “Bag clip” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Bag clip with sealing ridge
Set of four bag clips
1 h1 part
Freezer bag clip
34 min1 part
Clip for paper bags
23 min1 part
Something wrong with this model? Report a problem