Bag clip with sealing ridge
19 min1 part
Set of four bag clips
3D printing1 partBeginner-friendlyNo supports
Four bag clips in a single print – for the open bags in the cupboard: rice, pasta, sugar, nuts. Each clip takes bags up to 70 mm wide when folded and is 86.5 mm long and 12 mm wide, with a sealing ridge and a snap hook. All four lie on the bed one below the other and need 86.5 × 108 mm. The hole in the spring hangs them on a hook in the kitchen, so they are always at hand.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 86.5 × 107.99 × 12 mm
- Print time
- ≈ 1 h
- Filament
- ≈ 25 g PETG
- Parts
- 1
Print settings
- Material
- PETG
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print flat as shown, without supports – the clip comes off the printer open. Close it once after printing: press the arms together until the upper arm clicks in under the nose of the hook. To open, push the tab of the hook outwards. PETG springs best and copes with the freezer; PLA works too.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size as printed: 86.5 × 108 mm, 12 mm high
- Clamping length 70 mm, 12 mm wide
- With sealing ridge and groove
- Hole in the spring: 6 mm, to hang it up
- 4 clips in one print
This model comes from the “Bag clip” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Bag clip with sealing ridge
Bag clip for coffee bags
31 min1 part
Freezer bag clip
34 min1 part
Clip for paper bags
23 min1 part
Something wrong with this model? Report a problem