Electronics enclosure for 70 × 50 mm boards
1 h 39 min2 parts
Electronics enclosure for 65 × 30 mm boards
3D printing2 partsNo supports
A slim electronics enclosure for boards in the 65 × 30 mm format, with four bosses for M2.5 screws 58 × 23 mm apart and a screwed lid with vents. That is the footprint of the Raspberry Pi Zero and Zero 2 W: a wide opening in the front wall leaves the mini HDMI and both micro USB ports free, and 12 mm above the board is enough for a soldered pin header. Prepare the microSD card before you close the case, because its slot is not cut out.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 87 × 38 × 23.1 mm
- Print time
- ≈ 1 h
- Filament
- ≈ 26 g PLA
- Parts
- 2
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print the case with the opening up and the lid with its outer side down – no supports needed. The screws cut their own thread: turn them in slowly. For the screwed lid: M3 countersunk screws.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Outside with lid: 87 × 38 × 23.1 mm
- Inside: 83 × 34 × 18.6 mm
- Board: screws M2.5 × 8 mm (4 pcs)
- Lid: countersunk screws M3 × 12 mm (4 pcs)
This model comes from the “Electronics enclosure” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Electronics enclosure for 70 × 50 mm boards
Electronics enclosure for 85 × 56 mm boards
2 h 8 min2 parts
Enclosure for 40 × 30 mm boards without holes
42 min2 parts
Vented enclosure for 100 × 70 mm boards
3 h 19 min2 parts
Something wrong with this model? Report a problem