Electronics enclosure for 70 × 50 mm boards
1 h 39 min2 parts
Enclosure for 40 × 30 mm boards without holes
3D printing2 partsNo supports
A small electronics enclosure for 40 × 30 mm boards without mounting holes: the board rests on two ledges and the lid is press-fit. It suits sensors and small modules, with 15 mm of space above the board, vent slots in the lid and a cable opening in the front wall. Nothing clamps the board, so fix it on the ledges with a dot of hot glue; if the lid is too tight, give it more clearance in the generator.
Download
Calculated in your browser. Nothing is uploaded.
Join in
- Size
- 48 × 38 × 25.6 mm
- Print time
- ≈ 42 min
- Filament
- ≈ 17 g PLA
- Parts
- 2
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print the case with the opening up and the lid with its outer side down – no supports needed. The screws cut their own thread: turn them in slowly. For the screwed lid: M3 countersunk screws.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Outside with lid: 48 × 38 × 25.6 mm
- Inside: 44 × 34 × 21.6 mm
- The board rests on two ledges
This model comes from the “Electronics enclosure” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Electronics enclosure for 70 × 50 mm boards
Electronics enclosure for 85 × 56 mm boards
2 h 8 min2 parts
Vented enclosure for 100 × 70 mm boards
3 h 19 min2 parts
Drawer organizer for cables and chargers
9 h 44 min2 parts
Something wrong with this model? Report a problem