Electronics enclosure for 70 × 50 mm boards
1 h 39 min2 parts
Electronics enclosure for 85 × 56 mm boards
3D printing2 partsNo supports
An electronics enclosure for boards in the 85 × 56 mm format, with four bosses for M2.5 screws 58 × 49 mm apart and a screwed lid with vent slots. That is the footprint of the Raspberry Pi 4 and 5, and the 25 mm of space above the board leaves room for tall sockets and a small heatsink. The ports are not cut out: the case has one opening in the front wall, which you place in the generator at the connector you need most, such as the power cable.
Download
Calculated in your browser. Nothing is uploaded.
Join in
- Size
- 107 × 64 × 36.1 mm
- Print time
- ≈ 2 h 8 min
- Filament
- ≈ 58 g PETG
- Parts
- 2
Print settings
- Material
- PETG
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print the case with the opening up and the lid with its outer side down – no supports needed. The screws cut their own thread: turn them in slowly. For the screwed lid: M3 countersunk screws.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Outside with lid: 107 × 64 × 36.1 mm
- Inside: 103 × 60 × 31.6 mm
- Board: screws M2.5 × 8 mm (4 pcs)
- Lid: countersunk screws M3 × 12 mm (4 pcs)
This model comes from the “Electronics enclosure” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Electronics enclosure for 70 × 50 mm boards
Enclosure for 40 × 30 mm boards without holes
42 min2 parts
Vented enclosure for 100 × 70 mm boards
3 h 19 min2 parts
Drawer organizer for cables and chargers
9 h 44 min2 parts
Something wrong with this model? Report a problem