Electronics enclosure for 85 × 56 mm boards
2 h 8 min2 parts
Electronics enclosure for 70 × 50 mm boards
3D printing2 partsNo supports
An electronics enclosure for 70 × 50 mm circuit boards with four M3 holes 63 × 43 mm apart, closed by a screwed lid with vent slots. It gives prototypes and small controller boards a tidy home, with 20 mm of space above the board and an opening in the front wall for the cable. Measure the hole spacing of your board centre to centre before printing; if it differs, enter your values in the generator, which also lists the screw lengths you need.
Download
Calculated in your browser. Nothing is uploaded.
Join in
- Size
- 92 × 58 × 31.1 mm
- Print time
- ≈ 1 h 39 min
- Filament
- ≈ 44 g PLA
- Parts
- 2
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print the case with the opening up and the lid with its outer side down – no supports needed. The screws cut their own thread: turn them in slowly. For the screwed lid: M3 countersunk screws.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Outside with lid: 92 × 58 × 31.1 mm
- Inside: 88 × 54 × 26.6 mm
- Board: screws M3 × 8 mm (4 pcs)
- Lid: countersunk screws M3 × 12 mm (4 pcs)
This model comes from the “Electronics enclosure” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Electronics enclosure for 85 × 56 mm boards
Enclosure for 40 × 30 mm boards without holes
42 min2 parts
Vented enclosure for 100 × 70 mm boards
3 h 19 min2 parts
Drawer organizer for cables and chargers
9 h 44 min2 parts
Something wrong with this model? Report a problem