Electronics enclosure for 70 × 50 mm boards
1 h 39 min2 parts
Electronics enclosure for 60 × 40 mm boards
3D printing2 partsNo supports
An electronics enclosure for 60 × 40 mm boards with four M2 holes 55 × 35 mm apart and a press-fit lid with vent slots. It suits small perfboards and modules of this size, with 20 mm of space above the board and an opening for the cable in the right end wall. Measure the hole spacing of your board centre to centre before printing; if it differs, enter your values in the generator, and if the lid is too tight, give it more clearance there.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 68 × 48 × 30.6 mm
- Print time
- ≈ 1 h 9 min
- Filament
- ≈ 29 g PLA
- Parts
- 2
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print the case with the opening up and the lid with its outer side down – no supports needed. The screws cut their own thread: turn them in slowly. For the screwed lid: M3 countersunk screws.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Outside with lid: 68 × 48 × 30.6 mm
- Inside: 64 × 44 × 26.6 mm
- Board: screws M2 × 8 mm (4 pcs)
This model comes from the “Electronics enclosure” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Electronics enclosure for 70 × 50 mm boards
Electronics enclosure for 85 × 56 mm boards
2 h 8 min2 parts
Enclosure for 40 × 30 mm boards without holes
42 min2 parts
Vented enclosure for 100 × 70 mm boards
3 h 19 min2 parts
Something wrong with this model? Report a problem