Electronics enclosure for 70 × 50 mm boards
1 h 39 min2 parts
Electronics enclosure for 51 × 21 mm boards
3D printing2 partsNo supports
A small electronics enclosure for boards in the 51 × 21 mm format, with four bosses for M2 screws 47 × 11.4 mm apart and a press-fit lid. That is the size of the Raspberry Pi Pico, Pico W and Pico 2, and the opening in the left end wall sits right in front of the micro USB port. Solder the wires straight to the board, because pin headers pointing down would not fit underneath; if the lid is too tight, give it more clearance in the generator.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 59 × 29 × 22.6 mm
- Print time
- ≈ 38 min
- Filament
- ≈ 16 g PLA
- Parts
- 2
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print the case with the opening up and the lid with its outer side down – no supports needed. The screws cut their own thread: turn them in slowly. For the screwed lid: M3 countersunk screws.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Outside with lid: 59 × 29 × 22.6 mm
- Inside: 55 × 25 × 18.6 mm
- Board: screws M2 × 8 mm (4 pcs)
This model comes from the “Electronics enclosure” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Electronics enclosure for 70 × 50 mm boards
Electronics enclosure for 85 × 56 mm boards
2 h 8 min2 parts
Enclosure for 40 × 30 mm boards without holes
42 min2 parts
Vented enclosure for 100 × 70 mm boards
3 h 19 min2 parts
Something wrong with this model? Report a problem