Sorting insert for building bricks

3D printing2 partsBeginner-friendlyNo supports

A drawer insert with 12 compartments for building bricks, sorted by colour, size or set. Each compartment is 73 × 64.7 mm and 48.8 mm deep; the insert fits a drawer of 300 × 200 mm inside and is 50 mm high. As it is larger than most print beds, it comes in two parts that stand side by side in the drawer. Small pieces stop disappearing, and tidying up after building is quick.

The file is made in your browser. We only count how often it is downloaded.

Size: 299 × 199 × 50 mm
Print time: ≈ 10 h 8 min
Filament: ≈ 263 g PLA
Parts: 2

Print settings

Material: PLA
Layer height: 0.2 mm
Infill: 15%
Walls: 2
Supports: none

Tip: Print with the opening facing up, no supports needed. If the parts come out a little too wide, increase the clearance.

Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.

Adjust it

Organizer: 299 × 199 × 50 mm
Each compartment inside: 72.95 × 64.73 × 48.8 mm
Split into 2 parts (2 × 1) so each fits the print bed. A1 goes front left. STL comes as a ZIP with one file per part.

This model comes from the “Drawer organizer” generator. Open it there with these settings and change any size you like.

Open in the generator