Business card box with lid
1 h 50 min2 parts
Laser-cut pen holder
Laser cutting5 partsBeginner-friendly
A pen holder with finger joints, cut from five panels of 3 mm plywood or MDF, 80 × 80 × 100 mm on the outside and open at the top. Pens and pencils stick out far enough to grab, and the square inside also has room for scissors and a short ruler. Wipe the soot off the cut edges with a damp cloth before gluing, and stick felt pads under the bottom so it does not scratch the desk.
Download
Calculated in your browser. Nothing is uploaded.
Join in
- Size
- 80 × 80 × 100 mm
- Parts
- 5
- Material thickness
- 3 mm
Cutting settings
- Material thickness
- 3 mm
- Kerf
- 0.1 mm – Adjust it to your laser in the generator.
Worked for others:
Tip: Open the SVG or DXF in your laser software (e.g. LightBurn or xTool Creative Space). Cut lines are red and 0.1 mm thin. Cut a test corner first: if the joints are loose, raise the kerf; if they are too tight, lower it. Glue with wood glue.
Adjust it
- Outside: 80 × 80 × 100 mm
- Inside: 74 × 74 × 97 mm
- 5 parts, together 165.1 × 290.1 mm
This model comes from the “Laser box with finger joints” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Business card box with lid
Long pen box with lid
2 h 30 min2 parts
Desk drawer organizer with scoops
6 h 57 min2 parts
Desk edge cable holder
9 min1 part
Something wrong with this model? Report a problem