Desk drawer organizer with scoops

3D printing2 partsBeginner-friendlyNo supports

A desk drawer organizer with 3 × 2 large compartments for a drawer of 250 × 180 mm inside, each with a scoop at the front. Paper clips, pins, erasers, USB sticks and sticky notes each get their own place, and small things slide out over the curved floor with one finger. Put both parts in with the curves facing you – that is the front – and part A1 on the left.

Calculated in your browser. Nothing is uploaded.

Size: 249 × 179 × 40 mm
Print time: ≈ 6 h 57 min
Filament: ≈ 185 g PLA
Parts: 2

Print settings

Material: PLA
Layer height: 0.2 mm
Infill: 15%
Walls: 2
Supports: none

Tip: Print with the opening facing up, no supports needed. If the parts come out a little too wide, increase the clearance.

Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.

Adjust it

Organizer: 249 × 179 × 40 mm
Each compartment inside: 81 × 87.7 × 38.8 mm
Split into 2 parts (2 × 1) so each fits the print bed. A1 goes front left. STL comes as a ZIP with one file per part.

This model comes from the “Drawer organizer” generator. Open it there with these settings and change any size you like.

Open in the generator