Round tolerance test 10 mm
14 min2 parts
Square tolerance test 10 mm
3D printing2 partsBeginner-friendlyNo supports
A square tolerance test: a 10 × 10 mm pin and a plate with six square holes, from 0.1 to 0.6 mm clearance per side. It is meant for parts with flat sides such as sliding lids and slots, which often need a little more clearance than round parts because inside corners print slightly rounded. Also try the pin turned by 90°: if it fits only one way round, your printer's X and Y axes print slightly differently.
Download
Calculated in your browser. Nothing is uploaded.
Join in
- Size
- 103.2 × 23.18 × 10 mm
- Print time
- ≈ 14 min
- Filament
- ≈ 5.3 g PLA
- Parts
- 2
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 2
- Supports
- none
Worked for others:
Tip: Print the plate flat and the pin upright, without supports and with your usual settings. Then push the pin into the holes: where it goes in tightly is your clearance for press fits; where it turns easily, for moving parts. The number under each hole is its clearance per side – enter it as “Clearance” in the box and the other generators.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Clearance 0.1 to 0.6 mm per side, in steps of 0.1 mm
- Holes 10.2 to 11.2 mm (6 holes)
- Pin: 10 mm, 10 mm long
- Plate: 88.2 × 23.18 × 4 mm
This model comes from the “Tolerance test” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Round tolerance test 10 mm
Nozzle box with 8 compartments
57 min2 parts
Filament label “PLA”
4 min2 parts
Something wrong with this model? Report a problem