Circuit board spacer M3 × 5 mm
4 min8 parts
Spacer without hole 12 × 8 mm
3D printing4 partsBeginner-friendlyNo supports
Four solid round spacers without a hole, 12 mm across and 8 mm high, with chamfered edges. Glued under a storage box, a lamp base or a small device, they work as feet that let air underneath; on a cabinet door or a lid they act as bumpers. Fix them with a drop of glue or double-sided tape – printed in TPU, they become soft, non-slip feet.
Download
Calculated in your browser. Nothing is uploaded.
Join in
- Size
- 12 × 12 × 8 mm
- Print time
- ≈ 6 min
- Filament
- ≈ 2.4 g PLA
- Parts
- 4
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 2
- Supports
- none
Worked for others:
Tip: Print standing upright as shown, no supports needed. For washers under 1 mm use a layer height of 0.1–0.2 mm. The STL holds all pieces; in the 3MF each piece is its own object.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Outside 12 mm, no hole, 8 mm high
- Pieces: 4
This model comes from the “Spacer” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Circuit board spacer M3 × 5 mm
Spacer M3 × 10 mm
5 min4 parts
Hex spacer M4 × 10 mm
7 min4 parts
Washer M5
3 min10 parts
Something wrong with this model? Report a problem