Circuit board spacer M3 × 5 mm
4 min8 parts
Spacer M3 × 10 mm
3D printing4 partsBeginner-friendlyNo supports
Four round spacers for M3 screws, 10 mm high with a 3.4 mm hole, for parts that need a little more distance from their base. They lift a circuit board high enough for plugs and cables underneath, carry a cover plate above it or hold a small fan or display away from the housing. For boards that run warm, such as motor drivers or a printer mainboard, print them in PETG, which stays firm at higher temperatures than PLA.
Download
Calculated in your browser. Nothing is uploaded.
Join in
- Size
- 7 × 7 × 10 mm
- Print time
- ≈ 5 min
- Filament
- ≈ 1.4 g PLA
- Parts
- 4
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 2
- Supports
- none
Worked for others:
Tip: Print standing upright as shown, no supports needed. For washers under 1 mm use a layer height of 0.1–0.2 mm. The STL holds all pieces; in the 3MF each piece is its own object.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Outside 7 mm, hole 3.4 mm, 10 mm high
- Wall: 1.8 mm
- Pieces: 4
This model comes from the “Spacer” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Circuit board spacer M3 × 5 mm
Hex spacer M4 × 10 mm
7 min4 parts
Washer M5
3 min10 parts
Spacer without hole 12 × 8 mm
6 min4 parts
Something wrong with this model? Report a problem