Circuit board spacer M3 × 5 mm
4 min8 parts
Hex spacer M4 × 10 mm
3D printing4 partsBeginner-friendlyNo supports
Four hex spacers for M4 screws, 9 mm across flats and 10 mm high with a 4.5 mm hole, shaped like classic metal standoffs. The flat sides keep them from rolling off the bench and give pliers a grip while you tighten the screw; they suit model making, robot chassis and front panels. To hold two plates exactly 10 mm apart, push an M4 screw through one plate, the spacer and the other plate and secure it with a nut.
Download
Calculated in your browser. Nothing is uploaded.
- Size
- 10.39 × 9 × 10 mm
- Print time
- ≈ 7 min
- Filament
- ≈ 2.2 g PLA
- Parts
- 4
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 2
- Supports
- none
Tip: Print standing upright as shown, no supports needed. For washers under 1 mm use a layer height of 0.1–0.2 mm. The STL holds all pieces; in the 3MF each piece is its own object.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Outside 9 mm, hole 4.5 mm, 10 mm high
- Hex: 9 mm across flats, 10.39 mm across corners
- Wall: 2.25 mm
- Pieces: 4
This model comes from the “Spacer” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Circuit board spacer M3 × 5 mm
Spacer M3 × 10 mm
5 min4 parts
Washer M5
3 min10 parts
Spacer without hole 12 × 8 mm
6 min4 parts
Something wrong with this model? Report a problem