Circuit board spacer M3 × 5 mm
4 min8 parts
Spacer M6 × 20 mm
3D printing4 partsBeginner-friendlyNo supports
Four round spacers for M6 screws, 20 mm high with a 6.6 mm hole and a sturdy 2.7 mm wall. They mount a sign or an acrylic panel at a distance from the wall, leave room for a cable behind a cover, or serve as spacers in furniture and frames. For a panel that floats in front of the wall, the screw goes through the panel and the spacer into a wall plug; the 6.6 mm hole also takes 6 mm wood screws.
Download
Calculated in your browser. Nothing is uploaded.
- Size
- 12 × 12 × 20 mm
- Print time
- ≈ 16 min
- Filament
- ≈ 5.8 g PLA
- Parts
- 4
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 2
- Supports
- none
Tip: Print standing upright as shown, no supports needed. For washers under 1 mm use a layer height of 0.1–0.2 mm. The STL holds all pieces; in the 3MF each piece is its own object.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Outside 12 mm, hole 6.6 mm, 20 mm high
- Wall: 2.7 mm
- Pieces: 4
This model comes from the “Spacer” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Circuit board spacer M3 × 5 mm
Spacer M3 × 10 mm
5 min4 parts
Hex spacer M4 × 10 mm
7 min4 parts
Washer M5
3 min10 parts
Something wrong with this model? Report a problem