Garden hose connector 13 to 19 mm
27 min1 part
Pipe clip for 32 mm pipes
3D printing1 partBeginner-friendlyNo supports
A snap-in pipe clip for pipes with an outside diameter of 32 mm, such as drain pipes, conduit or the tubes of a workshop vacuum. The pipe snaps in from the front through a 28 mm opening and sits directly on the wall; two 4 mm screws hold the clip. For other sizes, just change the diameter in the generator. 63 × 30 × 20 mm; print it in PETG so it flexes without cracking.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 62.72 × 29.87 × 20 mm
- Print time
- ≈ 18 min
- Filament
- ≈ 6.7 g PETG
- Parts
- 1
Print settings
- Material
- PETG
- Layer height
- 0.2 mm
- Infill
- 20%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print standing up as shown, without supports. PETG is best for clips: it bends without breaking. 3 walls (perimeters) and 20 % infill.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 62.7 mm long, 29.9 mm deep, 20 mm high
- Holders: 1 for 32 mm
- Opening to clip in: 27.8 mm
- Distance from wall: 0 mm
- 2 holes for screws up to 4 mm, 50.7 mm apart
This model comes from the “Wall holder for round things” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Garden hose connector 13 to 19 mm
Ventilation duct reducer 100 to 125 mm
2 h 12 min1 part
Drain pipe reducer 40 to 32 mm
42 min1 part
Pond hose connector 25 to 32 mm
38 min1 part
Something wrong with this model? Report a problem