Garden hose connector 13 to 19 mm
27 min1 part
Pond hose connector 25 to 32 mm
3D printing1 partBeginner-friendlyNo supports
A double hose barb that joins a 25 mm (1 inch) and a 32 mm (1 1/4 inch) pond hose, both measured on the inside of the hose. It suits the low-pressure lines of pond pumps, filters, streams and fountains and lets you extend a hose or step up a size; it is not meant for pressurised lines or drinking water. Soften stiff spiral hose in hot water before pushing it over the barbs, then secure each end with a hose clamp.
Download
Calculated in your browser. Nothing is uploaded.
- Size
- 36 × 36 × 53.5 mm
- Print time
- ≈ 38 min
- Filament
- ≈ 14 g PETG
- Parts
- 1
Print settings
- Material
- PETG
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 3
- Supports
- none
Tip: Print standing as shown, no supports needed. With 3–4 walls (perimeters) it becomes watertight; a hose clamp holds hoses on the barbs.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 36 mm diameter, 53.5 mm high
- Bottom: hose barb for a hose 25 mm inside, 25 mm long
- Top: hose barb for a hose 32 mm inside, 25 mm long
- Narrowest opening: 21 mm
This model comes from the “Pipe adapter” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Garden hose connector 13 to 19 mm
Ventilation duct reducer 100 to 125 mm
2 h 12 min1 part
Drain pipe reducer 40 to 32 mm
42 min1 part
Circuit board spacer M3 × 5 mm
4 min8 parts
Something wrong with this model? Report a problem