Gridfinity bin 1 × 1
37 min1 part
Gridfinity bin 2 × 2 with scoop
3D printing1 partBeginner-friendlyNo supports
A 2 × 2 Gridfinity bin with a scoop: inside, the front wall curves down into the floor, so small parts cannot get stuck in the front corner. Flat, fiddly things like washers, nuts, beads or tiny screws come out with one finger instead of being picked out with your fingernails. To empty it, tip it over the scoop side: the curve pours the contents out cleanly, for example back into a bag or onto your work mat.
Download
Calculated in your browser. Nothing is uploaded.
- Size
- 83.5 × 83.5 × 45.8 mm
- Print time
- ≈ 1 h 46 min
- Filament
- ≈ 47 g PLA
- Parts
- 1
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 2
- Supports
- none
Tip: Print with the opening up, no supports needed.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Grid: 2 × 2 units, 6 units high
- Inside: 81.6 × 81.6 mm, 35 mm deep
This model comes from the “Bin for Gridfinity” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Gridfinity bin 1 × 1
Gridfinity bin 2 × 1
59 min1 part
Gridfinity bin 1 × 2 with label tab and scoop
1 h 16 min1 part
Gridfinity bin 2 × 2
1 h 32 min1 part
Something wrong with this model? Report a problem