Gridfinity bin 1 × 1
37 min1 part
Gridfinity bin 1 × 2 with label tab and scoop
3D printing1 partBeginner-friendlyNo supports
A Gridfinity bin one square wide and two deep, with a label tab at the back and a scoop at the front – the classic bin for small parts. Lined up side by side, a row of them sorts many kinds of screws, nuts or electronic parts in little space, and the labels tell you what is where. Set it with the scoop towards the front of the drawer: you slide parts out with one finger and read the label from above.
Download
Calculated in your browser. Nothing is uploaded.
- Size
- 41.5 × 83.5 × 45.8 mm
- Print time
- ≈ 1 h 16 min
- Filament
- ≈ 32 g PLA
- Parts
- 1
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 2
- Supports
- none
Tip: Print with the opening up, no supports needed.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Grid: 1 × 2 units, 6 units high
- Inside: 39.6 × 81.6 mm, 35 mm deep
This model comes from the “Bin for Gridfinity” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Gridfinity bin 1 × 1
Gridfinity bin 2 × 1
59 min1 part
Gridfinity bin 2 × 2
1 h 32 min1 part
Gridfinity bin 2 × 3
2 h 5 min1 part
Something wrong with this model? Report a problem