Gridfinity bin 1 × 1
37 min1 part
Gridfinity bin 1 × 1 with magnet holes
3D printing1 partBeginner-friendlyNo supports
A 1 × 1 Gridfinity bin with four holes in the feet for 6 × 2 mm magnets, 6 units high with a stacking lip. On a baseplate with magnets it sits much more firmly than a bin without – handy in a tool case you carry around – and it also holds on steel, such as the bottom of a metal toolbox. Press all four magnets in the same way round (mark one side with a pen first), and the bin holds the same however you turn it.
Download
Calculated in your browser. Nothing is uploaded.
Join in
- Size
- 41.5 × 41.5 × 45.8 mm
- Print time
- ≈ 38 min
- Filament
- ≈ 14 g PLA
- Parts
- 1
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 2
- Supports
- none
Worked for others:
Tip: Print with the opening up, no supports needed. Press the magnets into the holes after printing; a drop of glue holds them.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Grid: 1 × 1 units, 6 units high
- Inside: 39.6 × 39.6 mm, 35 mm deep
This model comes from the “Bin for Gridfinity” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Gridfinity bin 1 × 1
Gridfinity bin 2 × 1
59 min1 part
Gridfinity bin 1 × 2 with label tab and scoop
1 h 16 min1 part
Gridfinity bin 2 × 2
1 h 32 min1 part
Something wrong with this model? Report a problem