Star cookie cutter 70 mm
17 min1 part
Square cookie cutter 50 mm
3D printing1 partBeginner-friendlyNo supports
A square cookie cutter, 50 × 50 mm, with slightly rounded corners – for shortbread, crackers and cookies to decorate. Because squares fit edge to edge, you can cut almost the whole sheet of dough and have very little left to re-roll. For a cookie advent calendar, pipe the numbers 1 to 24 onto the squares with icing and pack them in small paper bags or line them up in a box.
Download
Calculated in your browser. Nothing is uploaded.
- Size
- 58 × 58 × 15 mm
- Print time
- ≈ 14 min
- Filament
- ≈ 5.2 g PLA
- Parts
- 1
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 2
- Supports
- none
Tip: Print as shown: rim on the bed, edge facing up, no supports needed. Use PLA or PETG, ideally one approved for food contact. Wash by hand in lukewarm water, not in the dishwasher. Layer lines can hold crumbs – to be safe, put cling film over the dough before cutting.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Cookie: 50 × 50 mm
- Cutter: 58 × 58 mm, 15 mm high
This model comes from the “Cookie cutter” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Star cookie cutter 70 mm
Small star cookie cutter 40 mm
11 min1 part
Heart cookie cutter 60 mm
13 min1 part
Round cookie cutter 60 mm
14 min1 part
Something wrong with this model? Report a problem