Star cookie cutter 70 mm
17 min1 part
Flower cookie cutter 60 mm
3D printing1 partBeginner-friendlyNo supports
A flower cookie cutter with six round petals, 60 mm from petal to petal – for Easter, spring and birthday tables. A dot of icing, half a glacé cherry or a chocolate button in the middle gives each flower its centre. For other flowers, set the number of petals in the generator anywhere from four to twelve; the cookie stays the same size.
Download
Calculated in your browser. Nothing is uploaded.
Join in
- Size
- 63.2 × 68 × 15 mm
- Print time
- ≈ 14 min
- Filament
- ≈ 5.1 g PLA
- Parts
- 1
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 2
- Supports
- none
Worked for others:
Tip: Print as shown: rim on the bed, edge facing up, no supports needed. Use PLA or PETG, ideally one approved for food contact. Wash by hand in lukewarm water, not in the dishwasher. Layer lines can hold crumbs – to be safe, put cling film over the dough before cutting.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Cookie: 55.2 × 60 mm
- Cutter: 63.2 × 68 mm, 15 mm high
This model comes from the “Cookie cutter” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Star cookie cutter 70 mm
Small star cookie cutter 40 mm
11 min1 part
Heart cookie cutter 60 mm
13 min1 part
Round cookie cutter 60 mm
14 min1 part
Something wrong with this model? Report a problem