Star cookie cutter 70 mm
17 min1 part
Christmas tree cookie cutter 80 mm
3D printing1 partBeginner-friendlyNo supports
A Christmas tree cookie cutter, 80 mm tall, with three tiers of branches and a short trunk. Iced in green and dotted with sprinkles, the trees turn the cookie plate into a small winter forest. The trunk is the narrowest part: lift each tree with a palette knife rather than your fingers, and roll the dough a little thicker than for round cookies so the trunk doesn't break off.
Download
Calculated in your browser. Nothing is uploaded.
Join in
- Size
- 66.31 × 88 × 15 mm
- Print time
- ≈ 19 min
- Filament
- ≈ 7.2 g PLA
- Parts
- 1
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 2
- Supports
- none
Worked for others:
Tip: Print as shown: rim on the bed, edge facing up, no supports needed. Use PLA or PETG, ideally one approved for food contact. Wash by hand in lukewarm water, not in the dishwasher. Layer lines can hold crumbs – to be safe, put cling film over the dough before cutting.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Cookie: 58.31 × 80 mm
- Cutter: 66.31 × 88 mm, 15 mm high
This model comes from the “Cookie cutter” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Star cookie cutter 70 mm
Small star cookie cutter 40 mm
11 min1 part
Heart cookie cutter 60 mm
13 min1 part
Round cookie cutter 60 mm
14 min1 part
Something wrong with this model? Report a problem